HiLetgo Stackable SD Card Shield for Arduino
8 sold in last 24 hours
- This SD card shield is a standard SD card / TF card break out board for Arduino. The SD card shield adds storage to your Arduino project.
- Stackable SD Card Shield is a stackable design Arduino SD / TF card expansion board. It supports direct insertion in the Arduino board to extend SD / TF read and write functions.
- SD / TF card expansion board uses the Arduino hardware ISP interface, so only supports SIP mode SD / TF card.
- This expansion board uses only a handful of Arduino pins, so the stack design allows you to plug in another expansion board on this board, provided that the same SPI pins are not used, such as Bluetoo
- Many electronic enthusiasts have provided Arduino with a simple documentation program. And we provide a simple TinyFAT file system library, you can easily achieve Arduino control SD / TF card reader -
Estimated shipping
Select a product to estimate shipping.Features: Compatible SD card, Micro SD card and SDHC card supportable.Prototype expand Library support Size: 53mm x 47mm Weight: 35g Pin With SD Card 5V VCC ---3v3 GND--GND D13---SD_CLK D12-- SD_OUT D11---SD_IN D10--SD_CS 1.The shield is missing pins for SCL and SDA If you need those two for I2C communication like a display shield, you have to use Analog pin 4 and Analog pin 52. How to build an eeprom programmer to program 2708s for computer?A: Set the switch to "3.3"and pressed on, SD cards require 3.3v or you could damage them.B:Installed the shield on a Mega 2560 R3 if you need lot of I/O pins forprom programmer,You can plug any shield, in general, into any Arduino as long as you "match" up the pins which are marked.C: Installed the shield on Mega,put the shield on the Duemilanove, changed the chip select pin to "10" again, and Cardinfo ran. Note that when you compile using the IDE, you have to CHANGE the target board to the board you are using or it just won't work.D:when you modify the code, make sure that you replace "10" with "53". 3.You can by googling ""SD shield 3.0"" and clicking on the iTEAD wiki link. A-Put the SD shield on whatever arduino you have. Using the labels on the shield and arduino, make sure the pins match.B-Use the wiki instructions' "Compatibility" section to find out what position the 3.3V/5V selector switch should be in, and whether you need to remove ALL 3 of the adjacent SPI Jumpers on the top of the board given the arduino board you're using. For the arduino DUE,you can remove these jumpers and keep the switch on 3.3V.
| Main Specification | |
|---|---|
| Manufacturer | HiLetgo |
| Brand | HiLetgo |
| UPC | 610708262626 |
| Compatible Devices | Personal Computer |
| Colour | Blue |
| Product information | |
| Flash Memory Type | Micro Sd or SD or SDHC |
| Technical Details | |
| Manufacturer Part Number | 3-01-0060-A |
| Country of Origin | USA |
| Item details | |
| Model Number | 3-01-0060-A |
| Features & Specs | |
| Additional Features | Stackable Design |
| Others | |
| Product Type | Internal Optical Drives |
| Item Weight Unit of Measure | 23 g |
| Hardware Connectivity | SDHC |